Nanjing Aokang Analytical Instrument Co., Ltd.Contact: Zhou Yuping Mobile: 13905149779
Address: No. 28 Shuanggao Road, Development Zone, Gaochun County, Nanjing
Metallographic detection of small and medium-sized pieces inlaid with special instruments, fast speed, easy and simple operation.
型金相试样镶嵌机（以下简称镶嵌机）适用于对不是整形、不易于拿的微小金相试样进行热固性塑料压制。 XQ-2B metallographic sample inlaying machine (hereinafter referred to as inlaying machine) is suitable for thermosetting plastic pressing of small metallographic samples that are not shaped and difficult to take. The grinding and polishing of the sample can be conveniently performed after forming, and it is also conducive to the determination of the microstructure under a metallographic microscope.
Structural Features Overview
Mounting machines work reliably under the following conditions:
海拔高度不超过1000米； l Altitude does not exceed 1000 meters;
周围介质温度不超过+40摄氏度，不底于-10摄氏度； l The temperature of the surrounding medium does not exceed +40 degrees Celsius, not less than -10 degrees Celsius;
空气在相对湿度不大于85%（在20摄氏度时）； l The relative humidity of the air is not more than 85% (at 20 degrees Celsius);
没有明显的振动和显颠簸； l No obvious vibration and obvious bumps;
周围没有导电压尘埃、爆炸性气体、及能严重破坏 l There is no conductive dust, explosive gas and serious damage around
Corrosive gases from metals and insulation.
This machine is a mechanical inlaying machine, rotating the external handwheel of the machine, and moving the lower mold of the pressed sample up and down in the rigid mold sleeve by a pair of bevel gears with an internal screw in the body. The sample is shaped under heating. The forming pressure in the sample preparation process is automatically compensated by the spring fixed in the collective, and the pressure of the sample pressing can be indicated by the signal lamp.
The inlaying machine is equipped with a digital temperature controller, so that real-time temperature display and temperature self-setting are realized, and a timer is configured, thereby realizing semi-automatic sample preparation and greatly improving work efficiency. Each set-up sample preparation time is 8-10 minutes, and an ideal sample as smooth as a mirror can be obtained.
试样压制规格 Ø 22 ×15mm; Ø 30 ×15mm; Ø 45 ×18mm Specimen pressing specifications Ø 22 × 15mm; Ø 30 × 15mm; Ø 45 × 18mm
加热器规格650W 220V l heater specifications 650W 220V
温度调节范围 100-180℃ lTemperature adjustment range 100-180 ℃
控制电源 电压波动不大于±15%,220V,50Hz l Control power supply voltage fluctuation is not more than ± 15%, 220V, 50Hz
外型尺寸 330X260X420mm l Overall size 330X260X420mm
净重 33Kg l Net weight 33Kg